Southrap- I made the frame myself with 17mm ply my builder friend had available- got him to cut it on the table saw.
Attached is a photo just before initial testing.
Grael, I ended up going for this ramps kit: www. aliexpress.com. Seems to be working fine once I got the 3rd party drivers.
Did a couple of prints with reasonable success, but the one I did tonight for some y-carriage clamps/brackets didnt come out 100%. The last 5of 53 layers were offset, like the y-belt had slipped a couple of teeth suddenly. Will troubleshoot this weekend when I have some fee time.
Will get the build summary done this weekend
Attached is a photo just before initial testing.
Grael, I ended up going for this ramps kit: www. aliexpress.com. Seems to be working fine once I got the 3rd party drivers.
Did a couple of prints with reasonable success, but the one I did tonight for some y-carriage clamps/brackets didnt come out 100%. The last 5of 53 layers were offset, like the y-belt had slipped a couple of teeth suddenly. Will troubleshoot this weekend when I have some fee time.
Will get the build summary done this weekend
